Download Print this page

F.I.T. PRO LED650 Manual page 2

Diving backup light

Advertisement

Operating Instructions
Turn ON: Pressing the Switch Button for less than one second.
Turn ON:
(Start : 100% brightness)
Turn OFF:
Turn OFF: Pressing the Switch Button for two seconds.
Adjustment brightness:
Adjustment brightness:
(On-State) Pressing the Switch Button for less than one
second.
100%
50%
50%
Turn On SOS:
Turn On SOS:
(OFF- State) Pressing the Switch Button for two seconds.
Switch mode:
Switch mode: ( SOS / Flash explosion)
(SOS- State) Pressing the Switch Button for less than one
second.
SOS
Turn OFF SOS:
Turn OFF SOS:
(SOS- State) Pressing the Switch Button for two seconds.
The diving light support AAA battery and 18650 Li-ion battery,
please select the battery type before using the light .
Activation Battery type selection:
Activation Battery type selection:
(OFF- State) Pressing the Switch Button for three seconds.
Care and Maintenance
1.Before you use the Diving Backup Light, read this manual
thoroughly to prevent accidental misuse, water intrusion or
damage.
2.The Backup Light be used underwater 100 meters (330ft).
3.The O Rings should be checked to ensure that they are free
from nay dirt, sand, hair and dust every time before closing
the Light head.
4.The O Rings should also be carefully checked for cracks or
blemishes. If cracks or blemishes occur, the O Ring should be
replaced immediately.
5. Gently and evenly apply a thin coat of grease to the entire
seal may help avoid abrasion and deterioration.
6. Remove the battery from the tail cap when finish traveling.
Warning
Do not open the tail cap when is diving
Do not place or store the Video Light in extreme high or low
temperature.
Do not store the Video Light with battery installed to prevent
battery off gassing or leaking.
Do not place the Video Light near any flammable material to
initiating a fire.
25%
25%
Flash explosion
Flash explosion
Select battery type:
Select battery type:
Battery type selection mode state: Pressing the Switch Button
for less than one second to switch the mode between 18650
Li-ion battery and AAA battery, pressing the Switch Button for
three seconds to save the selection.
18650 Li-ion battery
18650 Li-ion battery
(Green flash light)
Temperature Protection
When the inner temperature of flashlight is over the set
v alue, in order to keep the inner temperature in the control
r ange and the internal control circuit will automatic decrease
the brightness of LED.
Battery Level Indicator
When the battery level indicator low is flash red.
Caution:
Caution: When the battery level indicator is flash red.
1. Can't switch the mode and adjust the brightness;
2.The brightness will be 20% output;
3. The light will automatic turn off 10 minutes later.
Automatic Overheat Protection
When being used at a temperature higher than 55°C , the
light will automatically reduce the brightness by 50% to reduce
heat and protect the components.
4
Standard Warranty
Entitled to after-sales warranty services of the flashlight,
if there are any quality issues and the buyer can free change
the comodity with vendors within 15 days. And it can free to
maintance any problems within One Year. But it will charge
the cost of part after more than One Year. Exclude the rules
as follow;
1.Be artificially modified, damaged, dismantling the flashlight
and parts;
2. Error operation led to failure to use the flashlight (Such as
anti-loaded or wrong loaded the battery , ect.);
3.Battery leakage is caused the failure of flashlight;
4.Force majeure factors are demagered the flashlight
(Forexample: Earthquakes,Flood disaster ect.)
Troubles Solution
1.Try to solve the symptoms as following indications.
2.If can't solve please contact your local vender immediately.
Symptoms
Unwork of LED
Indicator shows
green when it
begins charge
6
(18650 Li-ion / 3*AAA)
AAA
AAA
(Red flash light)
Solution
1
、 To check the battery whether
installed backward.
2
、 To check the battery whether
has power .
3
、 To check the tail cap whether
has tightened.
1
、 To check that it right installed
the positive and negative of battery
or the sharp-nel is contacted good
with charger;
2
、 To check the battery whether
is well inserted into charger;
5
is
7

Advertisement

loading