Jumpers - Epson C824431 Manual

Note
• The printer will assume a setting of 1,200 BPS for switch
combinations other than those shown above.
• Since the maximum transmission speed (baud rate)
depends on your type of printer, refer to your printer's
manual for details.

Jumpers

The jumper is a small terminal used for connecting or
disconnecting a circuit. The jumper is on when the jumper
plug covers both wires of the terminal. Jumper settings can
be changed by either attaching or removing the rectangular
jumper plug. If the jumper is to be turned off, connect it to
just one of the two terminal pins as shown in the figure
below. By doing this, you can avoid losing the unused
jumper plug.
Figure 2. Jumpers
Jumper plug
OFF (open)
10
Jumper plug
ON (closed)