Download Print this page

AquaScape 17510 Installation Instructions

Statuary pump 75-145 gph

Advertisement

Available languages

Available languages

Quick Links

Statuary Pump
75-145 gph Installation Instructions
PaCkage InCludes:
• 75 or 145 gph Statuary Pump
• Instructions for Use
Features
• Fully submersible and energy efficient
• Powers ornamental fountains and statuary
Congratulations on your purchase of
this submersible pump.
You will find this pump ideal for use in small
ornamental fountains and statuaries. These pumps
are very energy efficient and designed to operate
Installation
1) If a fountain is not required, connect 1/2" hose
directly to the outlet adapter and secure with
hose clamp.
2) Plug pump cord into grounded outlet. Ensure
cable is protected — keep away from children
and garden hazards.
3) If fountain is in use, ensure fountain head is
above water level.
4) For proper operation, ensure that inlet is filled
with water.
Pump Performance
Model
gph full
Cord
open
length
75 gph
75
6'
145 gph
145
6'
Troubleshooting
Reduced Flow:
• Check pump and impeller for any blockages. It may
be necessary to take the impeller and prefilter out
and clean them.
• Check pipe and plumbing for any kinks or blockages.
Item #17510.11400.052006
• Prefilter system built in prevents clogging
• Fish safe, environmentally friendly materials
fully submerged. Made with environmentally friendly
materials, they are fish safe. The pumps are fitted with
a pre-filter system to prevent clogging and wear on the
impeller. The motors are epoxy encapsulated, not oil
filled, U.L. and C.U.L. approved.
Maintenance
1) Remove pump from electrical supply.
2) Wash pre-filter in fresh, running water. Never use
chemical detergents when cleaning. Handle filter
sponge material carefully.
3) Remove impeller, inspect and clean in running
water; replace if worn or damaged.
4) Reassemble pump; reconnect to electrical supply.
MaInTenanCe nOTes:
• Check cord periodically for sharp bends and correct.
• If pump is taken out of service, flush with fresh water and
allow to drain dry prior to storage.
gph
gph
Max
Tubing
@ 2'
@ 4'
Head
size
25
-
2.6 ft.
1/2"
135
20
3.6 ft.
1/2"
Pump is not pumping:
• Make sure nothing is blocking the impeller. It may be
necessary to clean pump.
©2006 aquascape, Inc. • all Worldwide Rights Reserved
saFeTY COnsIdeRaTIOns
• This product must be installed on an electrical circuit protected by a Ground Fault Circuit
Interrupter (GFCI). Refer to your electric supply dealer for details.
• If you have any questions or doubts about this product, consult a qualified electrician.
• Do not lift the pump by the power cord — it is not designed for portable use.
• Always disconnect from electrical supply before attempting to service or perform
maintenance procedures.
RePlaCeMenT PaRTs
To order replacement parts, contact your local Aquascape™ retailer.
Replacement Part
75 gph Impeller
145 gph Impeller
Watts
size
Code
5
S
Base
9
S
Feet
1
1
YEAR
YEAR
WARRANTY
WARRANTY
1
1
GARANTIE
GARANTIE
Item #
27500
DE 1 AN
DE 1 AN
20249
2
2
YEAR
YEAR
WARRANTY
WARRANTY
This Staturary Pump #17510 is warranted against
2
2
defects in materials or workmanship for a period of
GARANTIE
GARANTIE
24 months starting at the date of purchase by the
DE 2 ANS
DE 2 ANS
customer. This is the only warranty applicable for
this product. Our obligation under this warranty is
limited to the repair or replacement of the product
if it fails to operate. Neither Aquascape™, Inc. nor
the seller is liable for injury, loss or damage related
3
3
YEAR
YEAR
to the use of the product. However, this limitation is
not applicable in some states.
The warranty is void if any of the following is found:
1) Abuse of product by the customer.
WARRANTY
WARRANTY
2) Product connected to an electrical supply other
than specified.
3) Power cord cut to a length of less than three feet.
3
3
4) For pumps: (a) sealed motor housing opened;
GARANTIE
GARANTIE
(b) pump operated dry, with fluid supply shut
DE 3 ANS
DE 3 ANS
off and (c) pump used to circulate material other
than fresh water, light oils or other mild liquids at
approximately room temperature.
Outlet
Pump Cover
Motor
Pre-Filter
Impeller
Made in Italy for
Aquascape, Inc.
St. Charles, IL 60174 • Brampton,ON, L6T 5V7
www.aquascapeinc.com
IDD 06044481-ADI B060201

Advertisement

loading

Summary of Contents for AquaScape 17510

  • Page 1 PaCkage InCludes: YEAR YEAR • 75 or 145 gph Statuary Pump • Instructions for Use RePlaCeMenT PaRTs WARRANTY WARRANTY To order replacement parts, contact your local Aquascape™ retailer. GARANTIE GARANTIE Replacement Part Item # 75 gph Impeller 27500 DE 1 AN...
  • Page 2 DE 1 AN DE 1 AN l’eMBallage COMPRend : PIÉCes de ReCHange • Pompe pour statues et fontaines Pour commander des pièces de rechange, veuillez contacter votre détaillant Aquascape, Inc. de 75 or 145 gph YEAR YEAR Pièce de rechange no.