Advertisement
225 ID STORAGE OPERATION, CONT.
The following describes the ID Storage operation for the 225 with the ID Count set for
one prompt. Therefore, only one prompt name is referenced. Substitute the prompt
name entered during ID Storage Setup for the prompt name shown. Note that with the
ID Count set for more than one prompt, additional steps will be displayed.
Permanent Identification (ID) Strings
To Add a Permanent ID String
1. With the indicator in normal operations mode, press the MEM key. The display will
change to show Id=.
2. Enter up to a 12-digit alphanumeric ID string and press the ENTER key.
3. The display will show Ref=.
4. Using the alphanumeric keys enter up to 12 characters for the name and then press the
ENTER key.
5. The display will change to show a zero tare weight value stored.
6. If a zero tare weight is correct, press the ENTER key and proceed to the next step.
Otherwise, using the numeric keys, enter the tare weight and then press the ENTER
key or to use the current scale weight for the tare, press the GROSS key and then the
ENTER key.
7. The display will change to show a zero value for the accumulator associated with the ID
string.
8. If a zero value is correct, press the ENTER key to save it. Otherwise, using the numeric
keys, enter the accumulator value and then press the ENTER key to save it.
9. The indicator will return to normal operation.
To Edit or View a Permanent ID String
1. With the indicator in normal operations mode, press the MEM key. The display will
change to show Id=.
2. Enter the ID string and press the ENTER key.
3. The display will show Ref=XXXXXXXXXXXX. Note that XXXXXXXXXXXX is the
name associated with the ID.
4. If the name displayed is acceptable, press the ENTER key to save it. Otherwise, using
the alphanumeric keys enter up to 12 characters for the name and then press the
ENTER key.
5. The display will change to show the current tare weight stored.
6. If the displayed tare weight is correct, press the ENTER key and proceed to the next
step. Otherwise, using the numeric keys, enter the correct tare weight and then press
the ENTER key or to use the current scale weight for the tare, press the GROSS key
and then the ENTER key.
7. The display will change to show the accumulator value of the ID entered. NOTE: If the
accumulator value is greater than (>) 999,999,999, OVERFLOW will be displayed
8. If the displayed value is correct, press the ENTER key to save it. Otherwise, using the
numeric keys, enter the correct value and then press the ENTER key to save it.
9. The indicator will return to normal operation.
8545-0964-0M Rev A Satellite Series Technical and Operation
16
Advertisement
