koller ASZEP05-PL Instructions

AQUARIUM INTERNAL
POWER FILTER
UNIT INSTRUCTIONS
WITH IMPORTANT SAFEGUARDS
AND WARRANTY
UL Approved Pump Motor
120V 60 HZ .03A
For Household Use Only
Children under the age of 13 should be
supervised by an adult with the setup,
maintenance and fish care
FILTER MODEL # ASZEP05-PL
COPYRIGHT APRIL 2020
HANGER INSTALLATION
Locate the adjustable hanger bracket included
with your filter unit. It could have been placed
inside the filter cartridge compartment.
HANGER POST
HANGER BRACKET
Place the hanger bracket at 90° and align one
of the adjustment holes onto the mounting post
as shown in the illustration ABOVE.
Then rotate the hook until the hanger is vertical
as shown in the illustration BELOW.
PLACE WIRE THROUGH
CLEAT ON HANGER
MAINTAINING PROPER WATER LEVEL
Install the filter unit inside the aquarium by hanging
the filter onto the aquarium rim.
Raise or lower the Internal Filter by adjusting the
filter hanger bracket. Rotate the filter hanger
bracket 90º, remove it, and replace it in the next
hole.
ALSO SEE your Aquarium Kit Set Up Instructions
for recommended tank water level and other
important safety information.
IMPORTANT:
FOR THE FILTER TO FUNCTION PROPERLY THE
WATER LEVEL SHOULD BE MAINTAINED AT THE
RECOMMENDED LEVEL AT ALL TIMES.
MAXIMUM LEVEL
RECOMMENDED LEVEL
MINIMUM LEVEL
ALWAYS MAINTAIN WATER LEVEL AT
RECOMMENDED WATER LEVEL ON
FILTER TO ASSURE FILTER
FUNCTIONS PROPERLY
TECHNICAL DATA
FLOW RATE
FILTER WATTAGE (GPH)
ASZEP05-PL 2.6 20
REPLACEABLE
CARTRIDGE
XS