Huawei SUN2000-36KTL Quick Manual page 7

1. Remove the two security torx screws from the
maintenance compartment door using a security
torx wrench. (Set the two screws aside. Use the
idle ground screw on the chassis shell as the
standby screw, and the idle floating nut on the
chassis as the standby floating nut.)
3. Remove the AC terminal cover.
4. Remove an appropriate length of the jacket and insulation layer from the AC output power cable
using a wire stripper. (Ensure that the jacket is in the maintenance compartment.)
a. Three-core cable (excluding the ground
cable or neutral wire)
Core wire
c. Four-core cable (excluding the ground
cable but including the neutral wire)
Insulation layer Jacket
2. Open the maintenance
compartment door and adjust the
support bar. (The support bar is
bound to the chassis base.)
b. Four-core cable (including the ground cable
but excluding the neutral wire)
d. Five-core cable (including the ground cable
and neutral wire)
6