Table of Contents
Advertisement
4.4 Installation
4.4.1 Changing the Location of the Electrical Box
Depending on the installation space, changing the location of the electrical box is available.
When changing the location of the electrical box, follow the procedures below:
(1) Remove the service cover for the electrical box.
(2) Remove the service cover for the electronic expansion valve.
(3) Remove the electrical box.
(4) Remove the wiring from the wire clip and edge saddle, and move the electrical box.
After moving the electrical box, put the wiring into the edge saddle and bound with the wire clip.
(Refer to "Enlarged View of A" below.)
(5) Mount the electrical box.
(6) Rotate the service cover for the electronic expansion valve 180 degrees and mount it.
(7) Mount the service cover for the electrical box.
(1)
Service Cover for
Electrical Box
Enlarged View of A
Edge Saddle
MVD1
Electrical Box
(3)
(1)
(3)
Wire Clip
MVS1
Electrical Box
(Before Change)
Service Cover for
Electronic Expansion Valve
(2) (6)
(6)
(2)
(6)
A
(4)
Edge Saddle
Electrical Box
MVD1
Edge Saddle
Edge Saddle
(After Change)
* Make sure that the wiring is bound with the wire clips
in order to prevent the electrical box from entering
water.
7
(7)
(5)
(7)
(5)
Wire Clip *
MVS1
Advertisement
Table of Contents
