Advertisement
ASSEMBLY & ADJUSTMENTS
ATTACHING THE CROSS BRACES
This Roller Stand comes with two cross braces (A)
Fig.1 which need to be assembled to the main frame
of the stand.
1) Insert the fixing pin (B) Fig.1 into the opening at
the bottom of one of the frame legs.
2) Align the threaded hole of the fixing pin so the
threaded hole faces the opening.
3) Position the cross brace (A) Fig.1 as shown.
Using the provided hex. key (C), guide the cap
screw to fit in the fixing pin, and screw it into the
threaded hole of the fixing pin. Tighten securely.
4) Repeat steps 1-3 for the second cross brace and
leg.
ATTACHING THE ROLLER HEAD
The KRS-102 Roller Stand comes with one roller, as
shown in (A) Fig. 2. KRS-108 comes with a 3-in-1
roller, as shown in (B) Fig.2. The roller head
assemblies need to be assembled to the extension
arm.
1) Position the Roller head assembly (A or B) Fig.2
against the extension arm (C), line up the
mounting holes, and secure both parts together
using 2 cap screws, washers and nylon hex. nuts
(D).
ADJUSTING MODE OF 3-IN-1 ROLLER HEAD
The KRS-108 Folding Roller Stand comes with an
adjustable roller head, which allows you to set the
roller stand in either the 8 ball bearing mode, single
roller mode, or flat bar mode. To change the mode of
the roller head, pull the roller head outward, pivot
until the desired mode is obtained, lower the roller
head to lock it in place.
ADJUSTING HEIGHT OF ROLLER HEAD
The height of the roller stand is adjustable from 27" to 44" high. To adjust roller head
height, loosen the lock handle (A) Fig.3, raise or lower the extension bar/roller head
assembly (B) and retighten the lock handle.
Figure 1
Figure 2
Figure 3
Advertisement
