Trip computer
System that gives you information on the journey in progress (range, fuel consumption...).
Information display
F Press one of theses buttons to display the
various trip computer tabs in turn:
- The total distance.
- The trip "A".
- The trip "B".
- The Stop & Start partial time counter*.
- The Stop & Start global time counter*.
- The ambient temperature*.
- The current fuel consumption.
- The average fuel consumption.
- The remaining range.
- The average speed.
- The lighting dimmer.
Ambient temperature
In certain situations, the ambient temperature
may only be displayed after a delay or not at all,
in particular:
-
when stationary or at low speed (less than
about 16 mph (25 km/h),
-
where there is too much variation in temperature
(entering or leaving a garage, a tunnel...),
-
during very short journeys (less than about
2 minutes).
Lighting dimmer
When driving at night, this function allows
certain displays in the instrument panel to be
switched off to reduce visual fatigue for the
driver.
It operates only when the sidelamps are on.
F When the "Lighting dimmer" menu
is displayed, press and hold one of
the "DISP" buttons for access to the
adjustment.
F Then make repeated presses on one of the
two "DISP" buttons to increase or reduce
the brightness.
The display flashes to show you the
brightness chosen.
Trip reset
F When the trip required is displayed, press
one of the two "DISP" buttons for more
than two seconds.
Trips "A" and "B" are independent but their
use is identical.
For example, trip "A" can be used for daily
figures, and trip "B" for monthly figures.
* Depending on version.
Instruments
1
27