Water Outlet; Water Inlet - Lennox SW 036 Installation Instructions Manual

Job Name:___________________________________
Store No.___________Start-Up Date:______________
Address:_____________________________________
City:______________________________State:______
Start-Up Contractor:____________________________
Technician:___________________________________
Model No.:___________________________________
Serial No.:____________________________________
RTU No.:________ Catalog No.:__________________
Compressor Rotation j
Compr. Amps
L1 L2
1
2
Fluid type:Water and Propylene Glycol j Water and Ethylene Glycol j Water and Methanol j __________%
Stage 1 Pressure Differential
Water Inlet Temperature
Strainer cleaner installed? j
Blower Checks
Pulley/Belt Alignment j
Set Screws Tight
Nameplate Amps:_________
Volts:_______________
Motor Amps
L1_________
L2_________
L3_________
Notes:_______________________________________________________________________________________
____________________________________________________________________________________________
START-UP REPORT
Ambient Temp.________Return Air Temp.________ Supply Air Temp.________
Compressor Volts
L3 L1-L2
Water-To-Refrigerant Coil Checks
Stage 2 Pressure Differential
Water Outlet Temperature
Blower Rotation
j
j
Belt Tension
j
Volts
L1-L2_____________
L1-L3_____________
L2-L3_____________
Damage?
If yes, reported to:____________________________
Verify factory and field-installed accessories.
Check electrical connections. Tighten if necessary.
Supply voltage: L1-L2______L1-L3_____L2-L3_____
If unit contains a 208-230/240 volt transformer:
Check primary transformer tap j
Transformer secondary voltage: __________
Cooling Checks
L1-L3 L2-L3
1 _____________ 2 ____________
Min. Pos. j
Page 32
Inspections and Checks
R410A j
Yes No
Pressures CC Heater Amps
Disch. Suct.
Water Temperature Differential
Control Type
Accessory Checks
Power Exhaust Amps
Economizer Operation
Motor travel full open/close j
L1
None j