Advertisement
General
Welcome
Thank you for your purchase of Bryston's BR-4
infrared remote control. Among today's numerous
options for controlling electronic equipment,
the familiar IR remote control remains the most
accessible and easy to understand option for the
vast majority of listeners. Our BR-4 is designed
to facilitate access to the most commonly used
features in each of your compatible Bryston
components at once.
Features
The BR-4 is designed to control virtually all modern
Bryston electronics and to be intuitive to use while
maintaining Bryston's legendary durability.
•
Works with the following models:
SP2, BP6, BP16, BP17, BP-17³, BP-18, BP26
Preamps
B60R, B100, B135 SST² and B-135³ Integrated
Amplifiers
BCD1, BCD-3, BDP1,BDP1-USB, BDP2 Sources
BDA1, BDA2, BDA3, and BDA-3.14 D/A Converters
•
Easy to feel buttons
Configuring your BR-4
Each model has a specific 3 digit code which must
be entered to enable BR-4 control of that product.
Press and hold the CODE button until the red LED
flashes twice, then release the button. Usually this
takes about 5 seconds. While the LED remains
steadily lit, enter a 3 digit code. The LED will flash
twice after a valid code has been entered. There is
no need to set any special codes when using the
BR-4 remote with Bryston BCD CD Player, BDA-1,2
or 3 stand-alone digital to analog converter, or
BDP digital player. Page 3 indicates which remote
functions are available with each product.
2
BR-4 IR Remote Control
Code
Product
711
SP1.7/SP2
712
B100/B135/BP16/BP17
715
BCD1, BCD3
716
BDA1, BDA2
717
BDA3, uses device ID 6
719
BDP3, uses device ID 9
721
BP25/BP26
722
B60/BP6
750
Select D/A to use the BDA3.14 volume control.
Select Preamp to use the preamp volume
control.
751
Preamp volume control is used in either D/A or
Preamp mode.
Reset to factory default
Press 'CODE' for 5 seconds, until LED blinks. Release
'CODE' button.
Press '795' , LED will blink 4 times.
Volume Function
By default, the volume buttons control the
programmed pre-amp even when that mode is not
selected
To use the BDA3.14 volume control:
Press 'CODE' for 5 seconds, until LED blinks, release
'CODE' button. Press '717' , LED will blink 2 times.
Press 'CODE' for 5 seconds, until LED blinks. Release
'CODE' button. Press '750' , LED will blink 2 times.
To use the pre-amp volume control:
Press 'CODE' for 5 seconds, until LED blinks. Release
'CODE' button. Press '751' , LED will blink 2 times."
Controlling Your Equipment
Each diagram below indicates which BR-4 buttons
are available to control the specified Bryston
equipment. Volume and mute controls are always
enabled. To control the BCD, press the CD button.
To control the BDA and BDP products, press the DA
button. Other Preamp controls (printed in white on
the remote) are enabled by pressing PREAMP.
Advertisement
