Pc Recovery Mode - ARH SmartCAM Install Manual

PC RECOVERY MODE

The PC of the camera has a Recovery Mode primarily designed to maintain the communication
with the camera when it is unreachable for various reasons e.g. due to misconfiguration or the
IP address of the device is lost.
ENTERING RECOVERY MODE
Starting of the Recovery mode can be implemented in the
following way:
By magnetization:
1. Power off the camera.
2. Touch a magnet (not included) to the bottom of the PC at
the back of the camera and hold it in position. See figure
on the right.
3. Power on the camera and wait 5 seconds.
4. Remove the magnet.
5. Reach the camera via its default (192.168.1.4) IP address.
After this process, the following window will appear on your browser:
After clicking the [Restore Factory State] button on the bottom left side of the window, the PC
will return with the factory settings in a few seconds.
Page 12/14 SmartCAM Install Guide