VQ OrthoCare BioniCare Hand System Operating Manual page 10

BioniCare Hand System
®
Preparation and Treatment (cont.)
Applying the Generator Dock and Glove:
Pull the glove on the hand, making sure that your fingertips reach the ends of
the glove. Place the generator dock over the glove lining up the two velcro
dots with the strips of loop on the glove. Make sure that the straight edge of
the device is towards the hand and the curved edge is towards your elbow.
Attach the strap, placing the connector into the keyhole and pulling down to
secure. Adjust the elastic strap as needed to fit snugly on your wrist.
Connecting the Device:
Slide the device into the generator dock as shown below. Press the device
in place, making sure that you hear a click that will secure it in place.
Starting Your Treatment
Check that the components are in place and all connections and adjustments
are correct.
1. Turn the Signal Generator on by pressing the Select/Power button until
BioniCare appears on the screen. The screen will then advance to the
main treatment menu.
2. Press the
3. Increase the signal level by pressing the Increase Button
touch screen or the corresponding manual button. Increase the voltage
until you feel a tingling sensation in the hand or wrist.
8
play button.
on the