Advertisement
No.971-IS
I I n n s s t t r r u u c c t t i i o o n n S S h h e e e e t t F F o o r r T T o o o o l l # # 9 9 7 7 1 1
Disassembly Procedures
Warning: Disconnect the negative ground cable at the battery
1. Disassemble clutch per H-D service manual for appropriate year and model for the motorcycle you will be repairing.
2. Remove retaining ring H-D No.37904-90 from inner clutch hub. See Fig 1.
3. Support clutch shell with the side you removed retaining ring from, facing up on the press using suitable blocks, to raise up
approximately 6". The clutch shell needs enough space to remove the inner clutch hub.
4. Place hub remover tool No.2 with end marked "REMOVE" on clutch hub. See Fig 2.
5. Align with press ram and remove clutch hub from shell.
6. Remove the bearing retaining ring from the inside of the clutch shell. See Fig 3.
7. Turn over clutch shell and place No.1 bearing remover tool with side laser marked "REMOVE" into bearing. Press bearing out of
the clutch shell. See Fig 4.
ssembly Procedures
8. Place No.4, clutch shell
pedestal on the press with
shallow recessed side facing
up. Place the clutch shell on
pedestal stand so that the
bearing bore area sits squarely
on the pedestal. See Fig 5.
9. Clean all surfaces and apply
press lube to both the clutch
shell bearing mounting surface
and to clutch bearing O.D.
Position the new bearing
CAUTION: Wear safety glasses. Excessive force may damage parts!
See JIMS
555 Dawson Drive, Camarillo, CA 93012 Phone 805-482-6913 • Fax 805-482-9224
Division of Thiessen Products, Inc.
MARKED
"REMOVE"
Fig.1
®
catalog for Hundreds of top quality professional tools.
The last tools you will ever need to buy.
Fig.2
MARKED
"INSTALL"
MARKED
"REMOVE"
Fig.4
Rev A
10-13
Fig.3
Fig.5
2
Advertisement
