DeWalt DXV06G Instruction Manual page 9

6 gallon (23 l) wall-mounted wet/dry vacuum
Table of Contents

Advertisement

Available languages

Available languages

BLOWING OPERATION
WARNING:
Always wear safety goggles complying with ANSI
Z87.1 (or in Canada CSA Z94.3) when using as
a blower.
WARNING:
To avoid injury to bystanders, keep them clear of
blowing debris.
CAUTION:
Wear a dust mask if blowing creates dust which
might be inhaled.
CAUTION:
To reduce the risk of hearing loss, wear ear
protectors when using the vac/blower for
extended hours or when using it in a noisy area.
The vac contains a blowing feature. It has the
capability to blow sawdust and other debris. It can
be used to blow dust and debris out of garages or
off patios and driveways. Follow the steps below to
use the vac as a blower.
1. Locate blowing port on the vac.
2. Insert one end of the
hose into the blowing port.
3. Turn vacuum "ON".
ASSEMBLY
WALL MOUNT INSTALLATION
1. Mark the wall according to the location of the
wall mount screws.
2. Punch holes in marked positions.
3. Tape the plastic expansion screws into the holes.
4. Align the wall mount with the holes and
tighten the screws.
WARNING:
Inadequate mounting could
allow the unit to fall, causing injury and/or damage
to the unit.
INSTALLATION OF
ACCESSORY BAG BRACKET
Align the wall bracket hole position,
push the accessory bag
bracket upward, until hearing
the "click" sound, and the
installation is completed.
exible
1-7/8'' x 5' to 20'
ATTACH VAC
1. Grasp top handle with one hand and place other
hand under front of tank.
2. Align tab on back of vacuum (located near top
of tank) to engage with slot in center of wall
bracket as vacuum is lowered into bracket.
3. Push downward making sure slots on vacuum
(located near the bottom of the tank) attach to
the tabs located at bottom of bracket.
4. Lower top handle on vacuum to lay at on top
of housing. This will secure unit in bracket.
DETACH VAC
1. Grasp top handle with one hand and place other
hand under front of tank.
2. Pull upward until vacuum detaches from bracket
WARNING:
Do not remove lter cage and oat. The oat
prevents water from entering the impeller and
damaging the motor. The cage prevents ngers
from touching the moving impeller.
7
ENGLISH

Advertisement

Table of Contents
loading

Table of Contents