DeWalt DXV06G Instruction Manual page 7

3. Put the remote control close to the vacuum cleaner
rst (less than 0.5m [18 inches]). Press and hold the
pairing button of the remote control for about 3
seconds. The LED will ash and the vacuum unit will
make a sound (about 0.5 seconds) which is caused
by the motor rotation - this indicates that the remote is
no longer paired to this unit, and that the remote
control will need to be re-paired with the vacuum
before using it.
= Pairing button = On/off button
DRY PICK-UP
1. The lter must always be in correct position to
reduce the risk of leaks and possible damage
to vac. Make sure that the lter is completely
covering the lter cage. Make sure there are
no gaps between the lter and the lid. It is
very important to assemble the lter to the
cage without any possible leaks or tears.
Any leaks will allow the picked up debris
to be blown out of the blowing port and back
into the surrounding environment.
2. When using the vac to pick up ne dust,
it will be necessary to empty the dust tank and
clean or replace the lter at more frequent
intervals to maintain peak vac performance.
NOTICE:
A dry lter is necessary to pick up dry material. If
use the vac to pick up dust when the lter is
wet, the lter will clog quickly and be very dif cult
to clean. If the lter gets wet, replace it before
continuing to do dry pickups.
INSTALLING THE CARTRIDGE FILTER
The cartridge lter can be used for wet or dry
pick-up, installation is the same for both.
1. With the power head in an upside down position,
slide the cartridge lter down over the lter cage,
push the lter seals against the power head.
2. Turn the knob on lter cage clockwise to
tighten the lter into place.
3. To remove the lter for cleaning, turn the lter
knob counter clockwise till feel the tactile and
auditory cue, and make sure the knob arrow
align with the "Unlock" icon on the lter cage,
then slide the cartridge lter off the lter cage.
then grasp the step of knob tightly with ngers
to pull the cartridge lter out off the cage.
4. To clean the cartridge lter, shake or brush off
excess dirt or rinse (from the inside of the lter)
with water, dry completely (approximately 24
hours) and re-install.
NOTICE:
If the lter has been used for wet pick-up, it must
be cleaned and dried before dry pick-up.
NOTICE:
The vacuum requires only a minimum of conversion
when going from dry to wet pick up. A clean
cartridge lter may used for vacuuming small
amounts of liquids. For best results when
vacuuming large quantities of liquid, it is
recommended using the foam lter and install
the foam lter over lter cage; If the lter is not
removed, it will become saturated and misting may
appear in the exhaust. At this time, you should dry
or replace the cartridge lter to eliminate the misting
and possible dripping of liquid around the lid.
INSTALLING THE DISPOSABLE
FILTER BAG
1. Remove the power head of this vacuum by
pulling outward on the lid clips which is located
on each side of the vacuum, then lift the power
head up.
2. Slide the cardboard collar opening rmly onto
the vacuum port de ector until it stops against
the de ector wall.
5
ENGLISH
Lock