GE P2S930 Installation Instruction page 4

CONVERTING TO PROPANE
GAS (OR CONVERTING
BACK TO NATURAL GAS
FROM PROPANE)
This range leaves the factory set for use with
natural gas. If you want to convert to propane
gas, the conversion must be performed by a
qualified propane gas installer.
The conversion orifices and instructions can
be found on back of the range.
Keep these instructions and all orifices in case
you want to convert back to natural gas.
INSTALLATION AT HIGH ALTITUDE
Over 6000ft, product configured for natural gas or propane requires installation of kit (WB28X29254 for natural
gas and WB28X29255 for propane gas). Follow the instructions included with the kit.
Rear of Range
Terminal
Block
Cover
Orifice Kit
(location
may vary)
Screws to
remove
terminal
block cover
INSTALLATION INSTRUCTION
31-2000834 Rev. 0 09-20 GEA
P2S930