Mattel Maximum heat Owner's Manual

®
MICRO
REBOUND
REBOUND
RADIO CONTROL STUNT CAR
Keep these instructions for future reference as they contain important information.
VEHICLE
VEHICLE
VEHICLE OPERATION
VEHICLE OPERATION
Whip Antenna
Control
Stick
Battery Installation
1. Remove battery door and lift door to
open.
2. Install 3 AA (LR6) alkaline batteries
with polarity (+/–) as shown inside bat-
tery compartment.
3. Close battery cover.
4. Screw battery door shut.
Important Battery
Information
Insure that battery polarity is correct.
Use only batteries of the type recom-
mended (or equivalent).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-
zinc), or rechargeable (nickel-cadmium)
batteries.
Remove used-up batteries immediately.
Remove batteries if vehicle will not be
used for a long period of time.
For best perfomance use alkaline batter-
ies. Battery life may vary depending on
battery brand. Toy performance may
decrease as batteries weaken.
Do not recharge non-rechargeable bat-
teries.
ON/OFF
Do not short-circuit terminals.
Switch
Remove rechargeable batteries before
recharging. Recharge batteries only
under adult supervision.
Battery Contacts
Bent or dirty contacts may result
in loss of power.
Switch vehicle ON.
Step 1:
Push control
Step 2:
stick up to go
forward. Release
control stick
to stop.
SERVICE CENTER
WE CARE!
If you have questions or difficulty operating this vehicle,
DO NOT RETURN IT TO THE STORE!
Call Toll-Free 1-888-557-TYCO (1-888-557-8926)
for technical help, or RAPID parts and service assistance.
CONTROLLER
CONTROLLER
BATTERY INSTALLATION
Push battery cover down to remove.
1.
Install one 9V(6LR61) battery with polarity
2.
(+/–) as shown inside battery compartment.
Replace battery cover.
3.
NOTE: Your transmitter is equipped
with a special automatic ON
battery-saving feature. Just turn your
vehicle ON. Then push either
transmitter stick and you will be able
to run and control your vehicle.
Push control
Step 3:
stick back
for 360˚
spins.
To steer vehicle: push
Step 4:
control stick back to spin. Release
control stick to stop when vehicle is
facing the direction you want. Push
control stick up again to go forward.
36098-0920
27 MHz
+