JVC LT-19HA22U Operating Instructions Manual page 20

Other convenience functions
Country
Audio Language
Audio Language 2nd
Channel Set Up
OSD Language
Power Management
Power On LED
Time Setup
AV Input (LT-19.../LT-22...: AV1 Input)
20
Selected Items
On / Off
On / Off
Time Zone
Time
Auto Synchronization
Date
Time
Timer
Both On/Power
On Timer/Power
Off Timer/Off
Power On Timer
Power Off Timer
Sleep Timer
Off
10~120 Minutes
Auto Power Off
Off / 1 Hour / 2 Hours /
4 Hours
AV1 Input (LT-26.../LT-32...)
AV2 Input
Auto
RGB (only for AV1 input) when RGB is input.
CVBS
S-Video
Setup hint
Set the country where you use this product.
Select preferred audio language, if the current
watching DTV channel has more than one audio
language.
This option is not available for ATV channel.
•
Select second preferred audio language, if the current
watching DTV channel does not have the language
set in Audio Language option above. If the Audio
Language 2nd set here is not transmitted in the
channel, the first displayed audio language in channel
information is automatically selected.
This option is not available for ATV channel.
•
See page 12.
See page 12.
This feature controls the power management. If a
period of time is elapsed with no video signal in PC
mode, the power status is changed to stand by mode
automatically. When there is available video signal
again, the power status is returned to power on mode
automatically.
To cancel the lighting of
operation, set to "Off".
If the time displayed on the Channel Information
differs from the actual time, adjust the time offset until
the correct time zone is shown.
Normally, this would be done by selecting "Auto".
•
See page 13.
To activate or deactivate the Power On Timer and
Power Off Timer.
Set the timer using / and Number buttons (0-9).
Sleep timer switches the TV to standby after a defined
period of time.
To cancel the Sleep Timer, set to "Off".
When the Set and Remote key operation are not
operated with specified period by this setting(1/2/4
Hours), the power status is changed to stand by mode
automatically.
Only shown in AV-mode.
Factory setting, normally OK.
when Composite is input.
When S-Video is input.
indicator (P.7 (2)) during