Advertisement
3.1. Attach the silver removal press as in Fig.1. Note the inner
shoulder of the press fits inside the outer body of the bush.
Fig.1
3.2. Assemble as in Fig.2.
a)
Wind the force screw clockwise. The press will start to push the
bush through the trailing arm.
b)
Keep winding until the bush has been pushed all the way out of
the trailing arm.
NOTE! If any undue resistance is felt, remove the press and check
everything is correctly aligned. The bush will only push out in one
direction (Fig.2).
Outside edge of trailing arm
3.3. Fitting new bush.
a)
Before fitting the new bush, thoroughly clean and lubricate the
trailing arm.
b)
Thoroughly lubricate the bush sleeving to help ease refitting.
NOTE! The bush must be pressed through from the domed (inside)
edge of the trailing arm (Fig.3).
Fig.3
Lubricate sleeve
Rear of car
Front of car
Domed edge
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycle centre and disposed of in a manner
which is compatible with the environment.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey Limited
Fig.2
Black removal press
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
3.4. Assemble the press on the trailing arm as below (Fig.4).
a)
The bush should fit into the recess on the black replacement
press (Fig.3).
b)
To facilitate correct positioning of the bush, the replacement press
has a raised shoulder on the opposite edge to the cutaway.
Align the replacement press so the cut-away faces towards
the rear of the trailing arm (cut-away facing the rear of the car)
(Fig.5).
Fig.4
3.5. Wind the force screw clockwise.
NOTE! If any undue resistance is felt, remove the press and check
everything is correctly aligned.
a)
When the press makes contact with the trailing arm, the bush is
fully installed.
Cutaway facing rear of car
Fig.5
3.6. Remove the tool, clean and lubricate before returning to storage
case.
Fully installed bush
01284 757500
01284 703534
Bush
Rear of trailing arm (car)
Front of car
Rear of car
www.sealey.co.uk
W e b
sales@sealey.co.uk
email
VSE4780.V2
Issue No. 1 - 28/06/13
Advertisement
