Zenith 9107W Assembly Instructions Manual page 5

7.
Insert cambolts (O) into the middle holes and long dowels
(E) into the four remaining holes of the top side panels (6,7).
Fit the bottom fixed shelf (3) over the assembly as shown.
NOTE: This is the top assembly.
7
Finished
edge
9.
Attach the curved trim piece (4) to the left bottom panel (9),
by inserting the dowel (D) and using a large screw (A).
A
Finished
edge
9
11.
Attach 1 support rail (5) to the bottom side panels, using
large screws (A). NOTE: This is the bottom assembly.
Pg 5 of 16
3
O
E
6
4
A
Unfinished
edge
5
8.
Insert one short dowel (D) into the bottom hole in each end
of the remaining curved trim piece (4).
D
10.
Attach the right bottom panel (8) to the curved trim piece
(4), by inserting the dowel (D) and using a large screw (A).
4
12.
Insert the two remaining cams (H) into the bottom side
panels (8,9) with arrows pointing up.
Arrows on cams
should be pointing up.
9
4
Finished
edge
8
A
8
IS9178