Advertisement

Quick Links

BioXp™ 3250 system — User guide
Part number 43029
|
Revision 1.1
|
Effective 11DEC2020
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BioXp 3250 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for CODEX DNA BioXp 3250

  • Page 1 BioXp™ 3250 system — User guide Part number 43029 Revision 1.1 Effective 11DEC2020...
  • Page 2: Table Of Contents

    MANUAL SYMBOLS  4 Limited warranty a) Codex DNA, Inc.’s entire liability and your exclusive remedy if the Product fails to conform to the CANCELLING A JOB DURING A RUN  14 following warranty (a “Nonconforming Product”) shall be, at Codex DNA, Inc.’s sole option, either repair or...
  • Page 3: Safety Information

    Alternating current. Manual symbols This manual describes the use and maintenance of the Codex DNA BioXp™ 3250 system. Read this manual completely before putting the instrument into service. The following icons are used in this manual: Waste Electrical and Electronic Equipment (WEEE) directive: Do not dispose symbol. For more information, see Equipment disposal and WEEE compliance.
  • Page 4: Equipment Specifications

    Use only Codex DNA approved or supplied components. grounded to minimize the generation of static electricity. • Use only Codex DNA supplied power cord. Use of other power cords may compromise electrical protection • Do not use the ethanol reservoir if it is cracked.
  • Page 5: Site Preparation And Installation

    Placing an order To order custom BioXp™ application projects and reagents, visit the Codex DNA ordering portal at codexdna.com. After creating an account, you will be able to upload sequences and place an order.
  • Page 6: Setting Up The Bioxp™ System

    Configuration In order for the BioXp™ system to communicate with the Codex DNA server, you must open the 80/443 port through Configuration your network. In addition, the BioXp™ system will be making an outbound SSL connection (HTTPS/SSL) to logmein.com, codexdna.com and drive.google.com.
  • Page 7: Change The Clock (Optional)

    Change the clock (optional) Preparing the BioXp™ system for a run Press Set date and time Time Date Load tips by aligning the tip tray notch with the upper left corner of each tip tray retainer. Use the up and down arrows to set the time and date a.
  • Page 8: Initiating A Bioxp™ Run

    Attention Cancelling job Initiating a BioXp™ run If you press YES — Cancel job, the instrument will display a Storing covers Canceling job screen until the job cancel is complete. Once the deck is loaded, confirm that all components are START securely seated.
  • Page 9: Troubleshooting

    Attention • Before using a cleaning or decontamination method other than a recommended cleaner, contact Codex DNA to verify that the proposed decontamination method will not damage the equipment. Read job issue. Open the door to retry.
  • Page 10: Calibration

    Each BioXp™ system has been manufactured and calibrated to specifications. Do not attempt to disassemble any part of the Guidance and manufacturer’s declaration: Emissions system. Any such action will void the product warranty. In the event you should experience a product failure, call Codex DNA technical services at 858.228.4115.
  • Page 11 NOTE: U is the AC mains voltage prior to application of the test level. Codex DNA, Inc. 9535 Waples Street, Suite 100 San Diego, CA 92121-2993 USA 858.228.4115 Technical assistance: help@codexdna.com © 2020 Codex DNA, Inc. All rights reserved.

This manual is also suitable for:

43029

Table of Contents