Changing The Engine Oil; Changing The Oil - Toro 22602 Operator's Manual

Changing the Engine Oil

Note: Change oil more frequently when operating
conditions are extremely dusty.
Oil Type: Detergent oil with an API service rating
of SJ, or higher.
Crankcase Capacity: 2.1 qt. (2 l)
Viscosity: SAE 10W-30 is recommended for
general use. Other viscosities show in the chart
may be used when the average temperature in your
area is within the indicated range

Changing the Oil

1. Start the engine and let it run for five minutes.
This warms the oil so it drains better.
2. Park the unit so that the drain is slightly lower
than the opposite side to ensure that the oil
drains completely.
3. Set the parking brake and stop the engine.
4. Remove the drain plug and catch oil drained
through the slot in frame.
5. When the oil has drained completely, replace
the plug.
Note: Dispose of the used oil at a certified recycling center.
6. Remove the oil fill cap and slowly pour approximately 80% of the specified amount of oil
into the engine.
8. Slowly add additional oil to bring the level to the upper limit mark on the dipstick.
9. Replace the oil fill cap.
23
1
2
1. Oil dipstick 2. Oil fill hole 3. Upper limit 4. Lower limit
3
4