Toro 22602 Operator's Manual page 19

Pull machine away from stump, and rake chips away
from stump.
13. Place stump machine into position with cutting
blade near the front-top edge of the stump.
14. Set brake to the lock position.
15. Move the throttle up to the ENGAGE position.
16. Complete cutting stump by repeating step 12 again
and again until entire stump is cut to desired depth.
17. Stop the machine; refer to Stopping the Engine.
DO NOT let front of unit touch ground until you are sure cutting wheel has stopped turning.
A rotating cutting blade is very DANGEROUS!
Stay at the operating position and be sure that the blade comes to a complete stop before doing
anything else.
18