Advertisement
For use with Wolf 30"- 66" Pro wall hoods
1. If using the blower for a 22 Series hood (ONLY) you must remove the blower from the
mounting plate and install the motor directly to the hood rough in plate using
the hex nuts removed from the mounting plate; proceed to step 4 and discard the mounting plate
2. Install the 600 CFM blower by aligning the holes on the mounting plate to the studs
on the rough in plate.
3. Fasten the mounting plate to the rough in plate using the (6) 10-24 hex nuts
provided.
4. Plug the adapter plug to the blower "Molex plug"; plug the power plug into the
receptacle in the hood. Route the blower's power cord away from moving parts
MODEL 807614 INSTALLATION
MODEL 807614
REV. 7/07
Advertisement
