Assembly Of Mast To Base Illustration - Sunrise Medical Oxford STOWAWAY 140 User Instruction Manual

O x f o r d R a n g e o f M o b i l e H o i s t s
Assembly and Commissioning Instructions (cont.)
6. Check the legs of the lift open and close satisfactorily.
Ele ct ric model only
7. Check the red emergency stop button, located on the Controller is in the out
(off position).
8. Fit the handcontrol to the handcontrol socket located at the base of the
Controller.
Important
The handcontrol plug is indexed and can only be fitted one way. Do not force, but
make sure the plug of the handcontrol is firmly pushed into the socket.
9. Plug the actuator jack plug into the (left socket) actuator socket located at the base
of the Controller.
10. Push the up and down buttons on the handcontrol and confirm the boom rises and
lowers. The lift is now ready for use.
Hydraulic model only
7. Close the hydraulic unit release valve by turning the knurled black knob on the unit
fully clockwise.
Note: The release valve requires only minimal tightening to operate and should only
be closed finger tight. DO NOT apply excessive force to the valve knob as this will
result in damage to the valve.
8. Pump the handle of the hydraulic unit and confirm the ram raises the boom.
9. Open the release valve fully anticlockwise and check the boom descends. An
unloaded boom will not come down under its own weight, it will be necessary to
apply some pressure to the boom before it will descend.
Note: The release valve is fully open and encounters a positive end stop in less than
two full turns of the knob. DO NOT force the valve past the end stop as this will
result in damage to the valve.
10. Close the release valve. The lift is now ready for use.