Canon PowerShot S100 Firmware Update Procedure page 4

Compact digital camera

Hide thumbs Also See for PowerShot S100:

The firmware update confirmation screen appears,

so select [OK], and then press the [FUNC./SET]

button to start the firmware update.

After a short while, the firmware will be

overwritten

with the new version.

update takes approximately 2.5 minutes.)

During the firmware update, the lamp on the

back of the camera will blink. During this time,

please do not turn off the camera or operate

any of its controls.

camera malfunctions.

After the update is completed, the lamp on the

back of the camera will stop blinking, and the

power will be automatically turned off.

Step 4. Check whether the firmware of the camera has been updated to the new version

Press the [Playback] button to turn the camera on

in Playback mode.

Press the [MENU] button.

Use the Control Dial or the Up/Down/Right/Left

buttons to select the [Firm Update...], and then

press the [FUNC./SET] button.

Check whether the firmware of the camera has

been correctly updated to the new version. If

"Updated already" appears, the firmware has been

correctly updated to the new version.

Press the [POWER] button to turn off the camera,

and then remove the SD memory card.

This completes the firmware update.

After the firmware update is completed, please make sure to initialize the SD memory card to which the

firmware update file was copied before using the memory card. Also, please delete the firmware you

downloaded from your computer.

(The

Doing so could cause

Caution

- 4 -