LEEC W100 User Manual

Warming cabinet

Advertisement

USER MANUAL
LEEC WARMING CABINET
W100, W157 and W330
CONTENTS
1)
2)
INSTALLATION AND SWITCHING ON WARMING
CABINET
3)
4)
5)
6)
7)
Colwick Industrial Estate
E-mail: sales@leec.co.uk
Website: www.leec.co.uk
1
v1.0 March 2009
LEEC Limited
Private Road No. 7
Nottingham
NG4 2AJ
Tel: 0115 961 6222
Fax: 0115 961 6680

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the W100 and is the answer not in the manual?

Questions and answers

Summary of Contents for LEEC W100

  • Page 1: Table Of Contents

    USER MANUAL LEEC WARMING CABINET W100, W157 and W330 CONTENTS GENERAL DESCRIPTION INSTALLATION AND SWITCHING ON WARMING CABINET PROGRAMMING TEMPERATURE OVERTEMPERATURE CUT-OUT WARMING CABINET USEAGE CLEANING & DISINFECTING WARRANTY - PREVENTATIVE MAINTENANCE v1.0 March 2009 LEEC Limited Private Road No. 7...
  • Page 2: General Description

    TEMPERATURE CONTROLLER A very easy to program electronic PID temperature controller is fitted to the LEEC warming cabinet range. This controller is easy to use and enables quick programming of the warming cabinet chamber temperature.
  • Page 3 LEEC manufactures an under bench stand for the warming cabinet range to raise the warming cabinet sufficiently off the floor. Please contact LEEC if this is required.
  • Page 4 T o switch On the warming cabinet press in the Power button on the front facia panel. This button will illuminate Green when power is On. Front Facia Panel Power On The warming cabinet display will now light up displaying both the programmed temperature (SET) and actual inner chamber temperature (ACT) and the Heater (H) LED on the display indicates when the heaters are active.
  • Page 5: Programming Temperature

    PROGRAMMING TEMPERATURE DISPLAY The programmed temperature, Set Point (SET) is displayed in Green and the Actual Chamber Temperature inside the Warming cabinet Inner Chamber (ACT) is displayed LED Indicator next to the letter H (Heaters) on the display illuminates when the heaters are on.
  • Page 6: Overtemperature Cut-Out

    3 seconds. If the Low / High alarm values or the 2 minutes dwell need to be adjusted then please contact LEEC Limited for instructions. INDEPENDENT OVER TEMPERATURE SAFETY CUT-OUT An independent fail safe over temperature safety cut-out is fitted to this warming cabinet.
  • Page 7: Warming Cabinet Useage

    RESETTING OVER TEMPERATURE CUT-OUT In the unlikely event of the over temperature safety cut-out activating, this can be reset by Pressing in the Button at the Back of the warming cabinet. Over Temperature Cut-out at Rear of Warming cabinet Push In Red Button to Reset PROCEDURE FOR PROGRAMMING OVER TEMPERATURE CUT-OUT IF OPERATING TEMPERATURE IS ABOVE 37.0°...
  • Page 8: Cleaning & Disinfecting

    However, corrosion can still result from improper use of fungicides and bactericides. Never use any Chloride based chemicals for cleaning as this can result in permanent damage to the stainless inner chamber and this is not covered by LEEC warranty as no stainless steel is completely resistant to chlorine.

This manual is also suitable for:

W157W330

Table of Contents