Sealey POWER PRODUCTS SA106 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
SA106
1. SAFETY INSTRUCTIONS
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
!
WARNING! Disconnect the equipment from the air supply before changing accessories, servicing or performing any maintenance.
!
Keep the equipment clean and maintain it in good condition (use an authorised service agent).
"
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
"
WARNING! Ensure that the correct air pressure is maintained and not exceeded.
!
Keep air hoses away from heat, oil and sharp edges. Check hoses for wear before each use and ensure that all connections are secure.
"
DO NOT direct air from the air hose at yourself, others or animals.
#
Drain the compressor air tank daily. Water in the air line will damage your equipment.
"
When work is complete ensure that the air supply is turned off.
"
2. INTRODUCTION & SPECIFICATIONS
Suitable for workshop air supply set-ups. Regulator features locking control knob for pre-setting air pressure and pressure gauge. Filter has
manual drain facility with female 1/8"BSP outlet. Lubricator includes oil/air mix control and sight glass. Filter and lubricator are fitted with
metal bowl cages for protection. SA106, SA106FR and SA106R supplied with mounting bracket.
Filter/Lubricator/Regulator - SA106
Max. inlet pressure . . . . . . . . . . . . . . . . . . .150psi (10.3 bar)
Max. outlet pressure . . . . . . . . . . . . . . . . . . .125psi (8.6 bar)
Max. flow rate @ 100psi (6.9 bar) . . . . . . . . . . . . . . . .60cfm
Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25 micron
Lubricant . . . . . . .Sealey Air Tool Oil - ATO/500 or ATO/1000
Ports-Inlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4"BSP
Outlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4"BSP
Gauge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/8"BSP
Filter/Regulator - SA106FR
Max. inlet pressure . . . . . . . . . . . . . . . . . . .150psi (10.3 bar)
Max. outlet pressure . . . . . . . . . . . . . . . . . . .125psi (8.6 bar)
Max. flow rate @ 100psi (6.9 bar) . . . . . . . . . . . . . . . .70cfm
Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25 micron
Ports-Inlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4"BSP
Outlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4"BSP
Gauge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/8"BSP
Regulator - SA106R
Max. inlet pressure . . . . . . . . . . . . . . . . . . .150psi (10.3 bar)
Max. outlet pressure . . . . . . . . . . . . . . . . . . .125psi (8.6 bar)
Max. flow rate @ 100psi (6.9 bar) . . . . . . . . . . . . . . . .88cfm
Ports-Inlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4"BSP
Outlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4"BSP
Gauge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/8"BSP
SA106FR
INSTRUCTIONS FOR:
AIR REGULATOR, FILTER, LUBRICATOR RANGE
Models: SA106, SA106FR, SA106F, SA106L, SA106R
SA106F
Lubricator - SA106L
Max. inlet pressure . . . . . . . . . . . . . . . . . . .150psi (10.3 bar)
Max. outlet pressure . . . . . . . . . . . . . . . . . . .125psi (8.6 bar)
Max. flow rate @ 100psi (6.9 bar) . . . . . . . . . . . . . . . .60cfm
Lubricant . . . . . . .Sealey Air Tool Oil - ATO/500 or ATO/1000
Ports-Inlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4"BSP
Outlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4"BSP
Filter - SA106F
Max. inlet pressure . . . . . . . . . . . . . . . . . . .150psi (10.3 bar)
Max. outlet pressure . . . . . . . . . . . . . . . . . . .125psi (8.6 bar)
Max. flow rate @ 100psi (6.9 bar) . . . . . . . . . . . . . . . .53cfm
Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25 micron
Ports-Inlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4"BSP
Outlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4"BSP
WARNING! Filter and lubricator bowls are manufactured
from polycarbonate and must not be used at temperatures
over 125 F (52
O
Polycarbonate can be damaged and may fail if exposed to
certain solvents either internally or externally - strong
alkalies, compressor oils containing aromatic hydrocarbons
or fire retardant oils, or the fumes of any of these.
Clean with warm water only.
SA106L
C) or for pressures over 218psi (15 bar).
O
SA106/106FR/106F/106L/106R - 1 - 120406
SA106R