In The Event Of Problems - Lagostina BW761051 Instructions For Use Manual

TO DESCALE YOUR KETTLE:
• Using white vinegar which can be bought from hardware stores:
− Fill the kettle with 2 cups or 0.5 liters of white vinegar.
− Leave to stand for 1 hour without heating.
• Using citric acid:
− Boil 2 cups or 0.5 liters of water,
− Add 1 3/4 tablespoons (0.88 ounces) of citric acid and leave to stand for 15 min.
− Empty the kettle and rinse 5 or 6 times. Repeat if necessary.

In the event of problems

THERE IS NO EVIDENT DAMAGE TO YOUR KETTLE
• The kettle does not work
− Check that the kettle is properly connected.
− The kettle has been switched on without water or an accumulation of scale has
caused the overheat cut-out to operate: allow the kettle to cool and fill it with
water. Descale first if scale has accumulated.
• Switch the kettle on: the kettle should start working again after about 15 minutes.
IF YOUR KETTLE HAS BEEN DROPPED, IF IT LEAKS OR IF THERE IS VISIBLE DAMAGE
TO THE POWER CORD, THE PLUG OR THE BASE OF THE KETTLE.
• Return your kettle to your After-Sales Service Center, only they are authorized to carry
out repairs. See the warranty conditions and list of centers in the booklet supplied with
your kettle. The type and serial number are shown on the bottom of your kettle. This
warranty covers manufacturing defects and domestic use only. Any breakage or damage
resulting from failure to comply with the instructions for use is not covered by the
warranty.
• The manufacturer reserves the right to modify the characteristics or components of its
kettles at any time in the interests of the consumer.
• Do not use the kettle. No attempt must be made to dismantle the kettle or its safety
devices.
• If the supply cord is damaged, it must be replaced by the manufacturer, its after-sales
service center or a similarly qualified person, in order to avoid any danger.
10
Descaling