Table of Contents
Advertisement
trapped within the reservoir. Ensure the oil level is just below the oil filler plug hole. Re-install
the oil filler plug.
Pour a teaspoon of good quality air tool lubricant into the air supply inlet of the lift control valve
(see ill.). Connect to air supply and operate 3 s to evenly distribute the lubricant.
Check to ensure that the jack rolls freely (if equipped with) and that the pump operates
smoothly before putting it into service. Replace worn or damaged parts and assemblies with
original spare parts from the manufacturer.
This product is fitted for the common 1/4" NPT pressurised air plug nipple. When installing the
1/4" NPT nipple of your choice, ensure that thread tape or compound is used when servicing
connections.
Inspect before each use. Do not use if components are bent, broken or cracked. Broken parts
must be repaired before the jack is taken into action again.
Operation
Lifting
Assemble the two-piece handle and ensure that spring clips align with slots.
Secure the load to prevent inadvertent shifting and movement.
Position the jack near desired lifting point.
Close the release valve by turning it clockwise until it is firmly closed.
Caution: Use the handle provided with this product or an authorized replacement
handle to ensure proper release valve operation. Do not use an extender on the air
hose nor the operating handle when using to lift vehicles. Lift only on the manufac-
turer's recommended lift point and in accordance with the published guidelines in your
vehicle owner's manual. Always use the jack stands to support the load.
Hold the handle safely at the end. Pump the handle or press the hoist control valve together
until the load touches the ram. To stop the air operation, simply remove the handle of the hoist
control valve. Never activate/deactivate the hoist control valve in a different way then by hand.
Raise load to desired height, then immediately transfer the load to appropriately-rated support
devices such as jack stands.
Caution: This is a lifting device only. It is designed to lift a part of the total vehicle
(one wheel or axis). Always wear safety glasses when using this equipment. Center
the load on the ram before lifting it. Never work on, under or around load until it is
properly supported. Transfer the load immediately to appropriately rated jack stands.
Do not use this product for any purpose other than that for which it was inten-
ded. It is the owner's responsibility to keep labels and instructional material legible
and available. Replacement labels and manuals are available from the manufacturer.
Failure to heed these and all other warnings pertaining to this product can result in
sudden loss of lifted load resulting in death, personal injury and/ or property damage.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61974, 61975
Page 4
11
2020-1
Advertisement
Table of Contents
