Operation - WilTec QYL12 Operation Manual

6) Check to ensure that jack rolls freely (if equipped so) and that the pump operates smoothly before
putting into service. Replace worn or damaged parts and assemblies with original spare parts from
the manufacturer.
7) This product is fitted to accept the popular 1/4" NPT air nipple. When installing 1/4" NPT nipple of
your choice, ensure that thread tape or compound is used when servicing connections.
8) Inspect before each use. Do not use if bent, broken or cracked components are noted. Broken
parts must be repaired before the jack is taken into action again.

OPERATION

LIFTING
1) Assemble 2 pieces handle and ensure that spring clips align with slots.
2) Secure the load to prevent inadvertent shifting and movement.
3) Position the jack near desired lift point.
4) Close the release valve by turning it clockwise until it is firmly closed.
CAUTION: Use the handle provided with this product or an authorized replacement handle to ensure
proper release valve operation. Do not use an extender on the air hose nor the operating handle when
using to lift vehicle. Lift only on the manufacturer's recommended lift point and in accordance with the
published guidelines in your vehicle owner's manual. Always use the jack stands to support the load.
5) Insert and secure hand into hand sleeve. Pump handle or squeeze the lift control valve until sad -
dle contacts load. To end air operation simply release the grip on the lift control valve. NEVER
WIRE, CLAMP OR OTHERWISE DISABLE THE LIFT CONTROL VALVE TO FUNCTION BY ANY
MEANS OTHER THAN BY USING THE OPERATOR'S HAND.
6) Raise load to desired height, then immediately transfer the load to appropriately-rated support de -
vices such as jack stands.
CAUTION: This is a lifting device only. It is designed to lift a part of the total vehicle (one wheel or
axle). Always wear safety glasses when using this equipment. Center the load on saddle before lifting.
Never work on, under or around load until it is properly supported. Transfer the load immediately to
appropriate rated jack stands. Do not use this product for any purpose other than that for which
it was intended. It is the owner's responsibility to keep labels and instructional material legible and
available. Replacement labels and manuals are available from the manufacturer. Failure to heed
these and all other warnings pertaining to this product can result in sudden loss of lifted load resulting
in death, personal injury and/or property damage.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 16