Troubleshooting Guide - FILL-RITE 305RU Owner's Operation & Safety Manual

PROBLEM
Fluid leakage •Loose joints
•Dirty gasket
•Bad gasket
Counter reading •Calibration off
high or low •Air in product
•Measuring chamber or gears sticking
Meter shaft seal •Dirty seal
leakage •Bad seal
ABOVEGROUND TANK INSTALLATION
ELECTRICAL NOTE:
ELECTRICAL WIRING SHOULD BE DONE IN ACCORDANCE WITH APPROVED LOCAL
ELECTRICAL CODES AND BY A LICENSED ELECTRICIAN. THE PUMP SHOULD BE
PROPERLY GROUNDED, AND RIGID CONDUIT SHOULD BE USED WHEN INSTALLING
ELECTRICAL WIRING. WARNING: FAILURE TO FOLLOW THESE WIRING INSTRUCTIONS
MAY RESULT IN SERIOUS INJURY FROM ELECTRICAL SHOCK.
NOTE:
USE APPROVED PIPE COMPOUND
ON ALL PIPE THREADS.

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
•Tighten joints.
•Clean gasket and seat area.
•Replace gasket.
•Recalibrate meter.
•Find and repair air leaks in system.
•Clean or replace internal metering components.
•Clean O-ring seal and seat area.
•Replace seal.
9
SOLUTION