1. Manuals
  2. Brands
  3. AMBIC Manuals
  4. Farm Equipment
  5. Foam'n'Dip
  6. Operating instructions manual

AMBIC Foam'n'Dip Operating Instructions Manual

Teat dipping system
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

-1-
FN7501 V2 (27.09.16)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Foam'n'Dip and is the answer not in the manual?

Questions and answers

Related Manuals for AMBIC Foam'n'Dip

Summary of Contents for AMBIC Foam'n'Dip

  • Page 1 FN7501 V2 (27.09.16)
  • Page 2 FN7501 V2 (27.09.16)

  • Page 3: Installation

    SAFETY The “Foam’n’Dip” Teat Dipping System is designed exclusively for use in milking installations. Any application outside the use described in this operating manual will be taken to be not in accordance with the intended purpose. The manufacturer/supplier will not be held responsible for any losses arising as a result of such use.

  • Page 4: Maintenance

    When ready to dip, depress the trigger until foam (or Dip chemical) is level with the rim of Applicator (J) and raise fully onto teat (Fig. 5). A full bottle of chemical (250 ml) will normally suffice to dip 35-45 cows with foam, or 25-40 cows with dip.

  • Page 5: Specifications

    SPECIFICATIONS – Air – Farm Compressor • 8 Litres/minute minimum Power Source – Operating Pressure • 3 - 4 psi (0.2 - 0.28 bar) Max. – Air • 5 – 8 L/min at 3 - 4 psi (0.28 Output Bar max.) •...
  • Page 8 DRILLING TEMPLATE - Use the template below to mark out fixing holes for the Regulator housing. Ambic Equipment Limited, One Parkside, Avenue Two, Station Lane, Witney, Oxfordshire, OX28 4YF, England Tel: +44 (0)1993 776555 Fax: +44 (0)1993 779039 www.ambic.co.uk...

Table of Contents