Table of Contents
Advertisement
Chapter 2
SB IRQ Select
Change the SoundBlaster Pro interrupt signal.
The Choices: IRQ5 (default), IRQ7, IRQ9, IRQ10.
SB DMA Select
Change the SoundBlaster Pro direct memory access setting.
The Choices: DMA0, DMA1 (default), DMA2, DMA3.
MPU-401
Enable or Disable MPU-401 function.
The Choices: Enabled (default), Disabled.
MPU-401 I/O Address
Change the SoundBlaster Pro MPU-401 I/O address.
The Choices: 300-303H, 310-313H, 320-323H, 330-333H (default).
Game Port (200-207H)
Change the joystick connect port address.
The Choices: Enabled (default), Disabled.
Init Display First
This item allows you to decide to active whether PCI Slot or on-chip VGA first.
The Choices: PCI Slot (default), AGP.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read/ write. If you IDE hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal number of block mode
(most new drives do), select Enabled for automatic detection of the optimal
number of block read/ write per sector the drive can support.
The Choices: Enabled (default), Disabled.
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If install and FDC or the system has no
floppy drive, select Disabled in this field.
The Choices: Enabled (default), Disabled.
2-18
BIOS Setup
Advertisement
Table of Contents
