Uncrating Instructions - Best Tugs BRAVO 5 User Manual

UNCRATING INSTRUCTIONS

Please read these instructions
before beginning.
For any questions
call us at 800.914.2003
1. The lid is spray-painted with a red "1".
Remove the screws marked with red
paint. Remove the top lid from the
crate.
2. The end panel is spray-painted with a
red "2". Remove the screws marked
with paint. Remove the panel from
the crate.
3. Remove the plastic wrap from
around the Control Arm. Remove
the L-Handle Pin from the control
arm BEFORE lifting the control arm
(FIG 1). Rotate the Control Arm into
the lowest operating position (FIG
2). Insert L-Handle Pin until the pin
is visible from both sides. See page
8 for more instructions on adjusting
the Control Arm.
4. On the lateral sides of the crate,
marked with a red "3" - Remove the
screws marked with red paint. These
screws are in a 2x4 board, which is
holding the control arm and tires
in place. NOTE: Make sure to hold
the boards as you remove screws to
keep them from falling onto the tug's
cover.
5. Cut the strap holding the cardboard
box in place. This box holds the
accessories for your tug. Remove the
box from the crate.
1
Tools Needed:
•
Phillips Head
Screwdriver
(Drill/Impact is easiest)
•
7/16 Socket
1 1
3 3
Note: Foam filed tires
have a screw in the tire
from the factory. It is safe
to remove the screw.
2 2
FIG 1
FIG 2