Advertisement
1
Figure 1
1. Bolt (4)
3. Position the discharge tunnel and door assembly on the
mower, aligning the holes in the discharge tunnel with
holes in the mower (Fig. 2).
1
2
Figure 2
1. Discharge tunnel
2. Vertical bolts
4. Fasten the front right, rear right, and rear left corners
of the discharge tunnel to the mower, using the bolts
saved from step 2. Ensure that the shorter horizontal
bolt is installed in the front right location.
5. Secure the spring bracket and discharge tunnel to the
mower with the left front bolt (Fig. 3). A socket set
extension may be necessary (Fig. 4).
2
503
2. Cover and deflector
assembly
3
420
3. Horizontal bolt
1. Spring
2. Spring bracket
1. Socket set extension
6. Hook the end of the spring through the small hole on
the spring bracket (Fig. 3).
7. Open and close the discharge door to ensure that the
spring is not contacting any part of the engine and that
the door closes when the handle is released.
WARNING
POTENTIAL HAZARD
Ensure that the spring does not contact the gas
tank or any other part of the engine.
WHAT CAN HAPPEN
Wear between the spring and engine parts may
result in an unsafe operating condition.
HOW TO AVOID THE HAZARD
If the spring contacts any part of engine, do not
install the bagger kit on the mower and contact
an Authorized Toro Service Dealer before
proceeding.
Installing the Bagging Decal
1. Thoroughly clean the flat area of the mower behind
the discharge tunnel and to the left of the tunnel with
soap and water, then dry thoroughly.
2
1
2
3
Figure 3
3. Left front bolt
1
Figure 4
2. Spring bracket
1911
2
505
Advertisement
