Frigidaire A13110307 Use & Care Manual page 12

12
DOOR REMOVAL
Door Bearing Reversal For
Freezer and Refrigerator Doors
1. With a flathead screwdriver, pry out
the center hinge bearing from the
top of the refrigerator door (see
Figure 7A).
2. With a flathead screwdriver, pry out
the center hinge bearing plug from
the opposite side of the refrigerator
door (see Figure 7B).
B
Figure 7
3. Install the hinge bearing on the
opposite side by tapping it with a
hammer until it is flush with the end
cap. Repeat the process for the plug.
4. Reverse the door handle (see
DOOR HANDLE INSTALLATION
section if applicable).
5. Flip the refrigerator door over and
remove the screw from the door
closer using a Phillips screwdriver
and set it aside (see Figure 8A).
6. Pry out the hinge bearing from the
door with a straight screwdriver (see
Figure 8B).
7. Install the bottom hinge bearing on
the opposite side of the door (see
Figure 8C).
8. Flip the door closer over and install
on the opposite side of the door
(see Figure 8C).
A
Door Bottom
A
B
Door Closer
C
Figure 8
9. Repeat steps 1-8 for the freezer door.
10. Lower the refrigerator door in the
opened position on the bottom
hinge pin and close the door (see
Figure 9).
2
1
Figure 9
11. Screw in and tighten the center hinge
pin using an adjustable wrench.
12. Lower the freezer door in the opened
position over the center hinge pin
and close the door (see Figure 10).
2
1
Figure 10
Place the lower hinge cover between
the freezer door and refrigerator
door to keep it level while attaching
the top hinge (see Figure 11).
Figure 11