Pre-Configuration Settings; Http/Rtsp Setting; Set Ip Address By Using The Rm-Ip Setup Tool; Change The Default Password - Sony BRC-X400 Technical Manual

Technical Guide | BRC-X400/SRG-X400/X120
3.

Pre-configuration Settings

This section describes some pre-configuration settings you will need before activating the SRT
function for the cameras.

3.1. HTTP/RTSP setting

The HTTP/RTSP communication setting need to be enabled in order to communicate via network
before the SRT function of the camera is enabled. Please refer to the Operation Manual of the target
camera, and set the HTTP/RTSP communication setting.
Ref).
- The section of [Adjusting and Configuring the Camera through On-Screen Menus] – [SYSTEM
Menu] - [HTTP/RTSP] of the Camera's Operation Manual.
- The section of [Accessing the Camera from a Web Browser] – [Enabling HTTP/RTSP in the
Camera] of the Camera's Operation Manual.

3.2. Set IP address by using the RM-IP Setup Tool

For IP communication, the IP address needs to be set. You can use RM-IP Setup Tool to assign IP
address to the camera. Please refer to the RM-IP Setup Tool Guide for more details.
[Note] The DHCP setting cannot be enabled from the RM-IP Setup Tool.

3.3. Change the default password

When the procedure of 3.1 and 3.2 are performed, HTTP access to the camera is available. Please
change the default password (initial password) according to the Operation Manual of the Camera.
Ref).
The section of [Accessing the Camera from a Web Browser]-[Changing the Initial Password] of the
Camera's Operation Manual.
Sony
SRT introduction
4
Version 1.0