Technical Data; Installation - IB RUBINETTI BIRKIN 390 Fitting Instructions Manual

EN

TECHNICAL DATA

Minimum dynamic pressure:_______________________________________________________________0.5 bar
Maximum operational pressure:______________________________________________________________5 bar
Recommended operational pressure:_______________________________________________________1-5 bar
It's recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature:____________________________________________________________80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fi ne in time, must ensure compliance with the mode
of installation and maintenance described in this booklet. Relying on a qualifi ed plumber. Make sure
that the system is free from all debris and impurities existing.

INSTALLATION

Fig. 1: Drill a hole on the plane Ø28 mm - 1.1 in. Insert the stem of the spout, positioning the gasket
below it. Secure the spout with the fi xing kit. Screw the T-joint on the stem by inserting the sealing
gasket.
Fig. 2.1: Make two holes for the handles MIN Ø28 mm - 1.1 in, MAX Ø35mm - 1.37 in. Mount the fi xing
set on the pedestal. From below, insert the pedestal into the hole, place base and gasket. Screw the
base to the headwork and fi x it with the fi xing set. Install the handle insert on the broach, fi xing it
with the screw. Attach the marble handle, paying particular attention. When the two holes collimate,
screw the grain.
Fig. 2.2: Make two holes for the handles MIN Ø28 mm - 1.1 in, MAX Ø35mm - 1.37 in. Mount the fi xing
set on the pedestal. From below, insert the pedestal into the hole, place base and gasket. Screw the
base to the headwork and fi x it with the fi xing set. Install the handle on the broach, fi xing it with the
grub screw. Insert the cap cover hole.
Fig. 3: Screw the hose on the stem of the spout and the pedestal.
After connecting the body to the system, turn on the stopcocks and check that the mixer tap unit
operates correctly. Keep the tap pressurised for a few minutes checking eventual leaks.
CLEANING
Diversify the cleaning of the chromed parts from the marble ones.
Due to the fact that marble is precious and fragile, we suggest to cover it up with a towel during the
cleaning process of the metallic parts.
Chromed metallic parts
In order to obtain a correct cleanliness, exclusively wash them with soap and water, rewash and dry
them with a soft towel and deerskin. Avoid the usage of alcohol, solvents, solid or liquid detergents
which contain corrosive or acidic substances, abrasive sponges, swab with metallic strings because
they could irreversibly compromise the surfaces.
Marble parts
Use water with a low alcohol concentration to clean the marble parts, otherwise use a soap with a
neutral PH. Avoid the usage of all the acidic substances. Do not use lemon juice, citric acid, wine vi-
negar, apple vinegar, aggressive detergents and other solutions which may result acidic or corrosive.
DON'T LET THE MARBLE PARTS GET IN TOUCH WITH ANTI-LIMESCALE PRODUCTS due to the fact
that marble is a calcareous rock and it would be corroded. Avoid abrasive products and all the things
that could scratch the marble and wreck it irreversibly.
THE USAGE OF THIS KIND OF DETERGNETS DURING THE CLEANING OF THE MIXER EXCLUDE IB
RUBINETTERIE FROM ANY WARRANTY OBLIGATION.