Table of Contents
Advertisement
EN
TECHNICAL DATA
Minimum dynamic pressure: 0.5 bar
Maximum operational pressure: 5 bar
Recommended operational pressure: 1-5 bar
It's recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature: 80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fine in time, must ensure compliance with the
mode of installation and maintenance described in this booklet. Relying on a qualified plumber.
Make sure that the system is free from all debris and impurities existing.
INSTALLATION
Fig. 1: Fix the body to the fixing plate.
Fig. 2-3: Make a hole into the wall with a minimum measure of 150 mm - 5.90 in, 280 mm –
11.02 in, and MIN 80 mm - 3.14 in, MAX 90 mm – 3.54 in depth.
N.B.: The minimum and maximum measure have to be considered in relation to the finished
wall, cladding included.
Fig. 4-5: Fix the recessed body taking in consideration the perpendicularity, both vertical and
horizontal, by using a spirit level.
Fig. 6: Connect the body to the hydric system. It's recommended to use PTEF for granting the
endurance.
Fig. 7: Complete the wall leaving openings around the spout and the ring, so that they are
covered with rosettes.
Fig. 8: Remove the threaded plug and protective caps.
After connecting the body to the system, turn on the stopcocks and check that the mixer tap
unit operates correctly. Keep the tap pressurised for a few minutes checking eventual leaks.
Fig. 9: Insert the finishing rosette on the mouth.
Fig. 10: Crew the mouth onto the water system. It is advisable to use PTFE to ensure proper
sealing.
Fig. 11: Screw the bell on the headwork; insert the finishing rosette on the bell. Insert the
handle by fixing it with the screw. Move the finishing rosette of the spout against the wall.
CLEANING
In order to obtain a correct cleanliness, exclusively wash them with soap and water, rewash and
dry them with a soft towel and deerskin. Avoid the usage of alcohol, solvents, solid or liquid
detergents which contain corrosive or acidic substances, abrasive sponges, swab with metallic
strings because they could irreversibly compromise the surfaces.
THE USAGE OF THIS KIND OF DETERGNETS DURING THE CLEANING OF THE MIXER EXCLUDE
IB RUBINETTERIE FROM ANY WARRANTY OBLIGATION.
Advertisement
Table of Contents
