ABB Ability User Manual page 2

8. Measurements
3 axis vibration measurement, + wideband on z axis
3 axis magnetic field measurement
Acoustic / Ultrasonic microphone
Machine true skin temperature
9. Activation
Activation of sensor: Sensor is activated by using the NFC interface on a Smart
phone. Make sure it is enabled on the phone, and tap the phone
on top of the sensor, on left side of the screw hole, see Figure 2
below
Deactivation of sensor: Deactivation of sensor is done from mobile.
Figure 2 Location of NFC antenna in sensor, below axis cross
10. Commissioning
After activation, the sensor shall be commissioned by using the Smart Sensor App to be
downloaded from "Google Play" or "Iphone App store".
Detailed documentation on commissioning process can be found by following the link:
https://new.abb.com/motors-generators/service/advanced-services/smart-
sensor/hazardous-areas
11. Service
Product website:
URL: www.ABB.com\Smartsensor
Upon need for service, contact ABB.
Alternatively contact local ABB Sales office for Smart Sensor.
WARNING:
Contact with aggressive chemicals may cause severe damage to
the sensor's mechanical construction.
For details on chemical resistance, information can be found on
Chemical Resistance Charts for PBT (Polybutylene
Terephthalate), for example the one below made by Pisco:
https://gizmo-engineering.com/wp-
content/uploads/2019/10/chemical-resistance-chart-PBT3.pdf.
WARNING:
Sensors that have mechanical damage should be removed from
hazardous areas as soon as possible.
11.1 Batteries
When approaching end of battery life, the Smart Sensor will report
"battery failure" over its wireless interfaces.
The sensor must then be decommissioned and delivered for recycling.
WARNING:
Battery is not replaceable, no attempt on replacement shall be made.
This will destroy the sensor and violate its Ex protection.
12. Contact information
ABB AS
Department Digital Delivery
Ole Deviks vei 10
0666 Oslo
Norway
13. Product disposal
After decommissioning of Smart Sensors, they shall be delivered to local ABB office or
authorized receivers of electronic waste for recycling.
If returned to ABB, there is no waste fee to be paid.
Under no circumstance decommissioned Smart Sensor shall be mixed with general
household waste.
14. Compliance marks
0470
Declaration of Conformity
We ABB AS
Ole Deviks vei 10
0666 Oslo
Norway
declare under sole responsibility that the products
Device type: Condition Monitoring Sensor
Type names: Smart Sensor BASA, Smart Sensor BCHC,
Smart Sensor HCHC
are in compliance with the following European directives and regulations:
Directive Official Journal
2014/34/EU ATEX directive
2014/53/EU Radio Equipment Directive
(RED)
2011/65/EU Restriction of Hazardous
Substances Directive
Reference: Presafe 19 ATEX 14930X
The manufacturing process ensures the compliance of the product according to the technical
construction files.
CE marking was affixed in 2021.
Oslo 2021.03.19
Harmonized standards
IEC/EN 60079-0 :2017/2018
IEC/EN 60079-11 :2011/2012
EN 50303 :2000
EN 300 328 V.2.2.1,
EN 300 330 V2.1.1
EN 301 489-1/3/17 V2.1.1/2.1.1/3.1.1
EN61000-6-2 :2016
EN61000-6-3 :2006, A1:2011
EN60945 :2002
IEC/EN 61010-1 :2010
NA
...................................................
Marius Aarset
Vice President Digital Delivery
3BNP102777D017 G