Reassembly; Overloading - Berkel 705 Owner's/Operator's Manual

9. All removable parts can be soaked and scrubbed using a bristled brush and good quality deter-
gent approved for food processing equipment.
10. Rinse thoroughly and set aside to air dry while you are washing the machine case.
11. Sanitize all blade and frame assembly parts and tenderizer unit.
1. Replace stripper plates with solid flanges to the outside of the assembly, teeth to the center and
pointing up. (Front and back stripper plates for the tenderizer group are interchangeable.)
2. Inspect blades (especially if blades have been jammed by bone segments or have been mis-
handled). If any of the blades in the assembly are bent, replace with a new blade immediately,
otherwise you could damage the blade assembly.
3. With lock plate down, grasp blades by shaft ends and replace. Match color end plugs on blade to
matching colored dots on frame: Red for rear blade, white for front blade.
NOTE: Blade shafts are not interchangeable.
4. Raise locking plate up to lock blade assembly in place.
5. Replace the blade and frame assembly as previously shown and slide to the left to engage with
the clutches.
6. Replace safety cover by retracting pivot pin and latching into the housing. Lower safety neck
into closed position.
7. Plug power cord into wall receptacle.
THE TENDERIZER IS NOW READY TO USE.
The machine may jam from overloading or by a piece of bone accidentally being fed into the blades.
If this should happen:
1. Turn off machine immediately.
2. Unplug power cord.
3. Disassemble frame and blade assembly. Inspect for bent blades.
4. Remove obstructions, clean, inspect and reassemble.
R
EASSEMBLY
O
VERLOADING
705 & 705S O /O
WNER PERATOR
M • 7
ANUAL