Related Manuals for PVA FC100-CF1
Summary of Contents for PVA FC100-CF1
- Page 1 FC100-CF1 FILM COAT DISPENSE VALVE Version: B12-2241 Operation Manual 1 MUSTANG DRIVE COHOES, NY 12047 PHONE: 518-371-2684 FAX: 518-371-2688 info@pva.net www.pva.net...
-
Page 2: Theory Of Operation
This will assist in familiarizing you with the product and ensure a successful installation. As always, if any questions or problems arise, do not hesitate to contact PVA’s Valve Service Department for support. This department can be reached at PVA headquarters via telephone or e-mail. -
Page 3: Periodic Maintenance
Different nozzles are easily interchangeable to the valve by removing the nozzle lock nut (11). Nozzle sizes are selected based on the viscosity of the coating fluid and desired coating thickness. PVA’s application engineers can help you select the best nozzle for your valve. - Page 4 Setup The FC100-CF requires a 2-position, 4-way air solenoid valve to actuate the air section. The valve should be operated with clean, dry air between 60-100psi. Two #10-32 threaded air ports are located on the air section of the valve. The port located furthest from the midsection of the valve is air to close the valve.
-
Page 5: Operation
Tool Kit PVA offers standard tool kits for all dispensing valves. The tool kit for the FC100-CF is part number B12-1986, which includes all necessary tools and lubricating grease to perform maintenance on this dispense valve: B12-1986 Includes: Part Number... - Page 6 Routine Cleaning and Disassembly Cleaning and rebuilding the valve will be required from time to time. A spare parts kit, part # FC1-C4-SP is available with all the normal wear parts included. 1) Begin disassembly by removing air and fluid pressure from the valve. 2) Remove all pneumatic tubing and fluid delivery fittings, hoses, etc.
-
Page 7: Fluid Section
Assembly Instructions General All o-rings must be lubricated with a small amount of silicone grease. A small amount of removable thread locker should be applied to the set screw (19). Assemble the air section and fluid section separately prior to connecting the assemblies. -
Page 8: Spare Parts
3) Using the tip of a 3/32” Allen key, tighten the packing nut (6). Spare Parts PVA offers standard spare parts kits for all dispensing valves. These kits are stocked for immediate shipment and allow replacement of all wearable parts of the valve. - Page 10 BILL OF MATERIALS FOR FC100-CF (B12-2241): Refer to Drawing #112-2541 Item Part Number Description Quantity 114-1658 Nozzle Adapter V302 Seat 114-5247 Needle 114-6933 Fluid Section V305 Packing V306 Packing Nut V200 End Cap V201 Lower Air Body V202 Piston 114-6556 Upper Air Body 114-8053 Lock Nut, Nozzle...
-
Page 11: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action Valve does not - Air pressure to air section too low - Increase air pressure to 60-100 psi cycle - Packing nut is too tight - Loosen packing nut until valve just begins to cycle, retighten - Micrometer adjustment is - Back out micrometer adjustment by bottomed out... - Page 12 Unauthorized repair or modification of the enclosed product, and/or the use of spare parts not directly obtained from PVA (or from factory authorized dealers) will void all warranties.
Need help?
Do you have a question about the FC100-CF1 and is the answer not in the manual?
Questions and answers