Advertisement
How to Zero Calipers
mm
0.00
ZERO
Press ZERO to clear.
Calipers with a Preset Value Function
mm
0.00
SET
ZERO/SET
In 'INC' mode only; Press and
hold the ZERO/SET button
until SET fl ashes.
Caliper with ABS Function
mm
0.00
ZERO
Close Caliper. Press ZERO
button.
Trouble Shooting
Problem
Flashing display
No display
Erratic or frozen display
Erroneous reading
www.m-sure.co.uk - Allendale Group Ltd, Pindar Road, Hoddesdon, Hertfordshire. EN11 0BZ.
Images & Content ©2020 Allendale Group Limited. E&OE - Specifi cations subject to change without prior notice.
(MS-222 Series only)
mm
20.00
SET
PRE+/PRE-
Press PRE+ or PRE- to
increase or decrease
the value.
mm
10.00
Measure workpiece, for
example 10mm.
Possible Cause
Low voltage
Poor contact
Dead or weak battery
Poor contact
Contamination between beam & head
low voltage
Low voltage
Contamination between beam & head
Too much operating force
Low ambient temperature
Metric/Inch Conversion
mm
25.40
in/mm
Press in/mm to convert from
inch to metric display.
mm
20.00
SET
ZERO/SET
Once the desired value is
achieved, press the ZERO/
SET button.
ABS
mm
5.00
ABS
Press the ABS button once to
change between ABS mode
and INC mode.
(Not displayed)
Solution
Replace battery
Clean contact
Replace battery
Clean contact
Wipe Caliper clean
Replace battery
Replace battery
Wipe Caliper clean
Use pressure device
Store Caliper at normal room temperature
in
1.000
in/mm
The display will indicate
which units are being
displayed.
mm
20.00
SET
ZERO/SET
To recall the entered Preset
value press the ZERO/SET
button, IN 'INC' MODE ONLY.
mm
15.00
ABS
Press ABS to switch back to
Absolute display.
Advertisement
