Electrolux ERF4110AOW User Manua page 27

Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is
too high.
7.1 Replacing the lamp
2
1
Possible cause
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
The appliance is equipped with a longlife
LED interior light.
1.
2.
3.
4.
5.
6.
7.
Solution
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Disconnect the appliance.
Push the movable part to unhook the
lamp cover (1).
Remove the lamp cover (2).
If needed replace the lamp with a light
of similar characteristic and power. It is
suggested to use Osram PARATHOM
SPECIAL T26 0.8 Watts.
Install the lamp cover.
Connect the appliance.
Open the door. Make sure that the
lamp comes on.
ENGLISH 27