Advertisement
Elastic-powered Duck : Assembly Instructions
Assemble the tires
Glue
Fold in half along the fold lines,
glue together at the back and make a ring.
Adding curves to the part first will make it
easier to form a ring.
Assemble the axle
Add curves by pressing and rolling it
against the corner of a table,
with the printed side face up.
View from above
Cut three, equally-spaced slots in both ends
of part G, up to the grey valley fold line,
and bend them back.
*The fine strips of paper are thick and hard
so be careful of paper cuts.
After gluing parts L and M together back to back,
attach the ring you have made.
Assemble the front tires using parts C, D and F, in the same way.
Fold the edge to make a triangular prism,
and roll the piece up to form a stick
(about 4mm
wide).
Glue
Attach part K, enveloping it
around the parts you cut
and bent back.
Attach the other side too.
Glue
Back
Glue down the end after rolling.
Wind part H around and glue it down.
Attach part O to both ends.
Follow the same process to
assemble the other axle.
Advertisement
