Electrolux ERG29610 User Manual page 21

Problem
It is too warm in the freez-
er
It is too cold inside the
freezer
The appliance does not
work at all. The appliance
does not cool at all. Nei-
ther cooling nor lighting
works
Replacing the bulb
If you want to replace the bulb, do these
steps:
1. Break the circuit of the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of the
arrow.
3. Replace the bulb with one of the same
power (the maximum power is shown on
the light bulb cover)
4. Replace the light cover by sliding it into its
original position.
5. Reconnect the appliance.
6. Open the door and check if the light
comes on.
Possible cause
Doors are not shut properly or do
not close tightly
The Temperature Regulator may
be set incorrectly
Temperature Regulator may be
set incorrectly
The door does not close tightly or
it is not shut properly
Large quantities of food to be fro-
zen were put in at the same time
Food placed in the appliance was
too warm
Products to be frozen are placed
too closely to each other
Temperature Regulator may be
set incorrectly
The appliance may be switched
off
Plug is not connected to the
mains socket properly
Power does not reach the appli-
ance
There is no voltage in the mains
socket (try to connect another
appliance into it)
Solution
Check if the doors close well and
the gaskets are undamaged and
clean
Set a warmer temperature
Set a lower temperature
Check if the door closes well and
the gasket is undamaged and
clean
Insert smaller quantities of food to
be frozen at any one time.
Allow food to cool to room tem-
perature before storing.
Place the products in a way so that
cold air could circulate among
them
Set a warmer temperature
Switch on the appliance
Connect the mains plug properly
Try connecting another electrical
device to the power outlet
Call an electrician
electrolux 21