Software Configuration - Acksys EmbedAir Series User Manual

b)
The product must be connected to an RJ45 plug of your local network from
the RJ-100M plug of the EmbedAir/CB.
c)
The product must be connected to an RJ45 plug of your local network from
the RJ-1G plug of the EmbedAir/CB.
Check that the "LINK" LED turns ON at that point

SOFTWARE CONFIGURATION

3. Modify the default IP address 192.168.1.253
From any P.C the network, run the Windows application WaveManager
(found on the ACKSYS website)
Go directly to step 5 if the default IP address is compatible with your network.
Else, select the device and click on the "Configure" button. You can
configure the IP address or you can activate the DHCP client.
4. Device configuration
Click on the « Web » button to access the built-in web-based interface using
your web browser. The default page displays the device status. Now select
the "SETUP" tab.
You will be asked for a username and a password. You must choose the root
user. No password is required by default. You get access to the setup pages.
On the "wireless overview" page you should first select your country in order
to enforce applicable regulation rules. The country selector is located in the
global parameters, near the bottom of the page.
EmbedAir100/T board:
EmbedAir1000/Tx board:
-3-