Safety Information - Acksys EmbedAir Series User Manual

Since this product has no protecting case, only qualified staff must be allowed
to handle it, taking any useful precaution against
Ø
Electrical shocks
Ø
Burns due to some power components (radio, regulators...).
Ø
Static electricity
ASSEMBLY AND HARDWARE CONFIGURATION
Embedair100/x
Embedair1000/x2
EmbedAir1000/x4
1. Connect the RF cables to the EmbedAir/CB board according
to information below:
WiFi 1 :
WiFi 2 :
CELLULAR :
2. Connect the integrated antennas to the RF connectors.
3. Connect the UFL connectors to the radio according to the
information below:
Ant 1A to TX0
Ant 1B to TX1
Ant 2A Main to CH0 or MAIN
Ant 2B Aux to CH1 or DIV
Ant 2C GNSS to CH2 or GNSS
4. Take the EmbedAir board and embed it on the EmbedAir/CB
board
Secure with the 3 M3x5
1. Connect the power supply
Plug the power supply in the Jack plug of the evaluation board.
(You can use also an ATX power supply, read "Connectors" section for more
information)
The device has no ON/OFF switch. It turns on automatically when power is
applied. Check that the "PWR" LED turns on.
The Diag LED stays red for around 40 seconds, until the device is fully ready
to use. Then the Diag LED turns green.
2. Connect the Ethernet cable
a)
The product must be connected to an RJ45 plug of your local network from
the RJ45 plug of the EmbedAir.

SAFETY INFORMATION

Ant 1A (RPSMA)
Ant 1B (RPSMA)
Ant 2A Main (RPSMA)
Ant 2B Aux (RPSMA)
Ant 2C GNSS (RPSMA)
Ant 2A Main (SMA)
Ant 2B Aux (SMA)
Ant 2C GNSS (SMA)
EmbedAir 100/R or 100/K or 1000/Rx board:
: WiFi1
: WiFi1+ WiFi2
: WiFi1+ CELLULAR
-2-